![]() ![]() Commands that provide information about the state of the switch ports include: S1# show interfaces | include EthernetĬ. Before beginning the link aggregation between switches, verify the existing configuration of the ports that connect the switches to ensure that the ports will successfully join the EtherChannels. Assign each switch a hostname according to the topology diagram.ī. S3 F0/23, F0/24 Negotiated LACP Instructions Part 1: Configure Basic Switch SettingsĪ. Port Channel Table Channel Group Ports Protocol 1 S1 F0/21. In this lab, you will configure Port Aggregation Protocol (PAgP), a Cisco EtherChannel protocol, and Link Aggregation Control Protocol (LACP), an IEEE 802.3ad open standard version of EtherChannel.īefore beginning the configuration, review the EtherChannel Configuration Guidelines and Restrictions listed at the end of this activity. EtherChannel allows up to eight redundant links to be bundled together into one logical link. However, using only one link utilizes only half of the available bandwidth. ![]() As configured, only one of these links can be used otherwise, a bridging loop might occur. There are redundant uplinks between the switches. Part 4: Configure a Redundant EtherChannel Link Background.Part 3: Configure an 802.3ad LACP EtherChannel.Part 2: Configure an EtherChannel with Cisco PAgP.Part 1: Configure Basic Switch Settings.6.2.4 Packet Tracer – Configure EtherChannel (Instructor Version) ![]()
0 Comments
Leave a Reply. |